Configuring Avaya Aura Media Server

Last Updated : Jan 27, 2023 |

About this task

Ensure you have a DC2 site Avaya Media Server (AMS) registered in Communication Manager and the Survivable Processor settings. If the DC2 AMS is not on Communication Manager, add it.

Procedure

  1. To add a node name for AMS, do the following:
    1. Run the following command: change node-names ip
    2. In Name, type the AMS name.
    3. In IP Address, enter the IP address.
    4. Press F3.
  2. To add a signaling group that points to the new node, do the following:
    1. Run the following command: add signaling-group <x>
    2. In Group Type, type sip.
    3. In Peer Detection Enabled, type n.
    4. In Peer Server, type AMS.
    5. In Far-end Node Name, type DC2 AMS node name.
    6. In Far-end Network Region, type 1.
    7. Press F3.
  3. To add a media server, do the following:
    1. Run the following command: add media-server <x>
    2. In Signaling Group, type the group number you configured in the previous step.
    3. In Channel limit, type the required limit.
    4. Press F3.
  4. After configuring the AMS, run the following command: save translations