These settings are not mergeable. Changes to these settings will require a reboot of the system.
|
Field
|
Descripition
|
|
Name
|
Default = Blank.
A unique name for the tunnel. Once the tunnel is created, the name can be selected as a destination for traffic in the IP Route table.
|
|
Local Configuration
The IP Address and IP Mask are used in conjunction with each other to configure and set the conditions for this Security Association (SA) with regard to inbound and outbound IP packets.
|
|
IP Address
|
The IP address or sub-net for the start of the tunnel.
|
|
IP Mask
|
The IP mask for the above address.
|
|
Tunnel Endpoint IP Address
|
The local IP address to be used to establish the SA to the remote peer. If left un-configured, the system will use the IP address of the local interface on which the tunnel is to be configured.
|
|
|
Remote Configuration
The IP Address and IP Mask are used in conjunction with each other to configure and set the conditions for this Security Association (SA) with regard to inbound and outbound IP packets.
|
|
IP Address
|
The IP address or sub-net for the end of the tunnel.
|
|
IP Mask
|
The IP mask for the above address.
|
|
Tunnel Endpoint IP Address
|
The IP address of the peer to which a SA must be established before the specified local and remote addresses can be forwarded.
|
