MO name in log |
Alarm level |
Initial command to run |
Full name of MO |
DID-DS1 |
MAJ1 MIN |
test trunk grp#/mem# long |
Direct Inward Dial Trunk |
|
WRN |
test trunk grp#/mem# |
|
The DID-DS1 trunk provides a digital Direct Inward Dial (DID) trunk from a CO switch to the system through a DS1 link. A 24-channel DS1 link can support up to 24 DID-DS1 trunk calls simultaneously. A 32-channel link can support up to 30.
A DID-DS1 trunk can be used for digitized voice and data communications with DS1 signaling mode, for example, common-channel signaling. The DS1 Interface Media Module support wink-start and immediate-start trunks and Communication Manager signaling. Throughout this section, the term DS1 applies to DS1 Interface Media Module. For more information, see one of the following maintenance objects:
Media Module |
Maintenance object |
DS1 Interface Media Module |
MG-DS1 |
Not all tests are applicable to media modules. These tests will abort with error code 1412. This error can be ignored.
Two trunk service states are specified in the DID-DS1 trunk maintenance:
out-of-service |
The trunk is in a deactivated state and cannot be used for incoming calls. |
in-service |
The trunk is in an activated state and can be used for incoming calls. |
If a DS1 is out-of-service, every trunk on the media module is put into the out-of-service state, and a warning alarm is raised.
