Configuring a vector for the Transfer to User VDN

Last Updated : Jul 16, 2020 |
Prolog information
Metadata
Keywords:
Use this procedure to configure a vector for the Transfer to User VDN to initiate the Adjunct Route to Avaya Oceana®.
  1. Using SSH client, connect to the Communication Manager System Access Terminal (SAT) interface.
  2. Run change vector n.
    ADDITIONAL INFORMATION:
    n is the number that you entered in the Destination field of the VECTOR DIRECTORY NUMBER screen while creating the Transfer to User VDN.
  3. On page 1 of the CALL VECTOR screen, perform the following steps:
    1. In the Name field, enter the name of the vector as Transfer2Usr Vector.
      ADDITIONAL INFORMATION:
      This standard name makes maintenance and troubleshooting easier.
    2. Enter the details required from line 01 to line 10 as shown in the following screen:
      ADDITIONAL INFORMATION:
      Important:
      In line 06, you must specify the number of the first CTI-Link that you created while configuring the CTI-Link to Application Enablement Services. It is recommended that you use two Application Enablement Services and two CTI-Links for robustness. Add the second CTI-Link to the vector after line 06 if required. If your solution implements disaster recovery, configure up to four CTI-Links. You must ensure that you change the other lines in the vector as appropriate if you add multiple CTI-Links.
  4. Save the settings.