Creating a Virtual WAN Port

Last Updated : Mar 26, 2014 |

Procedure

  1. Select WAN Port.
  2. Click and select PPP.  
  3. In the Name field, enter either LINEx.y where:

    • LINE must be in uppercase.

    • x is the line number. For a PRI/T1 module in Slot A, this will be 1. For a PRI/T1 module in Slot B, this will be 5.

    • y is the lowest numbered channel number to be used by the WAN link minus 1. For example, if the lowest channel to be used is channel 1 then y = 1 - 1 = 0.

  4. In the Speed field, enter the total combined speed of the maximum number of channels sets in the Service.

    In this example, 12 channels x 64000 bits = 76800.

    Note:

    The maximum number of channels that can be used will be limited by the number of data channels supported by the system Control Unit and not already in use.

  5. In the RAS Name field, select the RAS name created when the new Service of that name was created.
  6. Click OK.
Related information
General System Configuration