Use these settings to configure a WAN port.
On IP500 V2 systems, these settings configure the leased line connected to the WAN port on the Control Unit. Normally this connection is automatically detected by the control unit. If a WAN Port is not displayed, connect the WAN cable, reboot the Control Unit and receive the configuration. The WAN Port configuration form is now be added.
These settings are not mergeable. Changes to these settings will require a reboot of the system.
Field |
Description |
Name |
The physical ID of the Extension port,. This parameter is not configurable; it is allocated by the system. |
Speed |
The operational speed of this port. For example for a 128K connection, enter 128000. This should be set to the actual speed of the leased line as this value is used in the calculation of bandwidth utilization. If set incorrectly, additional calls may be made to increase Bandwidth erroneously. |
Mode |
Default = SyncPPP Select the protocol required. The options are:
|
RAS Name |
If the Mode is SyncPPP, selects the RAS service to associate with the port. If the Mode is SyncFrameRelay, the RAS Name is set through the DLCIs tab. |
