Using DCP data-terminal dialing

Last Updated : Jul 28, 2021 |

About this task

A user can use DCP data-terminal dialing to set up and disconnect data calls directly from a data terminal as follows.

Procedure

  1. At the DIAL prompt, the user types the data number.
  2. If the call is queued, the message WAIT, XX IN QUEUE displays.

    The queue position XX updates as the call moves up in queue.

  3. To originate and disconnect a call, the user presses BREAK.

    If the terminal does not generate a two-second continuous break signal, the user can press originate or disconnect on the data module.

  4. The user can enter digits at the DIAL: prompt.