Configuring the signaling group

Last Updated : Sep 27, 2023 |

Procedure

  1. Enter add signaling-group n, where n is the signaling group number.
  2. Ensure that the Group Type field is set to H.323.
  3. Fill in the following fields:
    • Max number of NCA TSC: 1 or higher.

    • Max number of CA TSC: 1 or higher.

    • Trunk Group for NCA TSC: Type the number of the previously administered or associated trunk group.

    • Trunk Group for Channel Selection: Type the number of the previously administered or associated trunk group.

    • TSC Supplementary Service Protocol: a.

    • X-Mobility/Wireless Type: DECT.

    • Location for Routing Incoming Calls: blank or the location of the ADMM or RFS.

      Note:

      Administer the Location for Routing Incoming Calls field only when the multiple locations feature is enabled for IP DECT.

    • Near-end Listen Port: Port of the PE.

    • Far-end Listen Port: Port of the ADMM or RFS.

    • Far-end Network Region: Point to the associated network region.

    • Calls Share IP Signaling Connection: n.

    • Interworking Message: PROGress.

    • Enable Layer 3 Test: y for IP trunk supervision.

  4. Select Enter to save your changes.