Loudspeaker paging feature administration

Last Updated : Feb 12, 2020 |
Prolog information
Metadata
Keywords:
For a user experience similar to CS 1000, Avaya recommends that you configure the TAC to match the FFC that is used on CS 1000.
Before you begin
  • Ensure that Voice Paging is set up for the Avaya Aura® system. Refer to the Avaya Aura® Communication Manager Feature Description and Implementation guide to do the following:
    • Prepare to administer Loudspeaker Paging.
    • Set up Voice Paging over loudspeakers.
  • Ensure that you are using an MM711 card for loudspeaker paging.
  1. Log in to System Manager by using administrative credentials.
  2. Click ElementsCommunication ManagerElement Cut-Through.
  3. Click the Communication Manager instance for which you want to configure the Loudspeaker paging.
  4. On the Element Cut Through page, in the Command field, type the following command:
    ADDITIONAL INFORMATION:
    change paging loudspeaker
  5. Click Send.
  6. On the Loudspeaker Paging page, do the following:
    1. In the Port field corresponding to the zone number, type the physical port number of the paging trunk for this zone.
    2. Under Voice Paging, in the TAC field, type the TAC code to access the speakers in the corresponding paging zone.
    3. In the corresponding COR field, type the class of restriction number that you want to assign to the paging zone for voice paging.
      ADDITIONAL INFORMATION:
      Valid values are 0 to 995.
    4. In the corresponding TN field, type the tenant partition number for voice paging if tenant partitioning is used.
      ADDITIONAL INFORMATION:
      Valid values are 1 to 100.
  7. Click Done.