Provisioning the Autodial number

Last Updated : Jan 24, 2019 |
Prolog information
Metadata
Keywords:
The Device Adapter maps the CS 1000 Autodial to the Communication Manager Autodial read-write buttons.
The CS 1000 does not allow migration of Autodial destination numbers when migrating from CS 1000 to Device Adapter. You need to reprogram Autodial numbers after upgrading to Device Adapter.
Autodial programming scenario:
  1. Press the Autodial key while in the idle state.
  2. At the prompt, type the destination number.
  3. Press Autodial again to save the changes.
    ADDITIONAL INFORMATION:
    The number cannot be programmed if the Autodial button is configured with a predefined number by the administrator.