The Remote Cluster feature is configured to override user defined System Manager addresses for all Device Adapter endpoints. If the Remote Cluster feature is enabled and both primary IP addresses are empty, then the Device Adapter sends SNMP alarms.
Navigate to ElementsAvaya Breeze®ConfigurationAttributes.
Depending on whether you want to configure the Remote Cluster feature at a cluster level or a global level, do one of the following:
Click the Service Clusters tab, select the appropriate application cluster, and then select the service as DeviceAdapter.
Click the Service Global tab and select the service as DeviceAdapter.
Navigate to the Remote Cluster section and do the following:
In the Remote Cluster configuration enabled field, select the check box, and click Yes to enable the Remote Cluster configuration.
In the Primary SBC IPv4 Address field, type the primary SBC IPv4 address.
In the Secondary SBC IPv4 Address field, type the secondary SBC IPv4 address.
ADDITIONAL INFORMATION:
Note:
If both IPv4 and IPv6 addresses are available in the primary and secondary Avaya SBCE, then Device Adapter uses the IPv4 addresses.
