Type change station n, where n is the extension of the multiappearance telephone on which you want to create the bridged call appearance. Press Enter.
On the Station screen, click Next until you see the Per Button Ring Control? field.
Perform one of the following actions:
Type y to assign ringing separately to each bridged appearance.
Leave the default setting, n, to assign all bridged appearances to either ring or not ring as determined by the Bridged Call Alerting field.
In the Bridged Call Alerting? field, perform one of the following actions:
Type y if you want the bridged appearance to ring when a call arrives at the primary telephone.
Leave the default setting, n, if you want the bridged appearance to flash but not ring when a call arrives at the primary telephone.
In the Bridged Idle Line Preference? field, perform one of the following actions:
Type y if you want the user to lift the telephone receiver, then press the lighted bridged appearance button to connect to the call.
Leave the default setting, n, if you want the user to just lift the telephone receiver to connect to the call
In the Auto Select Any Idle Appearance? field, perform one of the following actions:
Type y to allow automatic selection of an alternate idle appearance for transferred or conferenced calls when another appearance of the bridged number is unavailable.
Leave the default setting, n, to prevent this automatic selection.
Click Next until you see the Button Assignments area.
In the Button Assignments area next to any available button number, perform the following actions:
Type abrdg-appr to create a bridged appearance of a single-line telephone.
Type brdg-appr to create a bridged appearance of a multiappearance telephone.
Press Enter.
The system displays the Btn and Ext fields.
In the Btn field, enter the button number from the primary phone that you want to use for the bridged call appearance.
