Administering PPM for DS1 media module

Last Updated : Sep 29, 2023 |

Procedure

  1. Type change ds1 n, where n is the number of the DS1 media module for which you want to administer PPM. Press Enter.

    The system displays the DS1 Media Module screen.

  2. In the Received Digital Metering Pulse Maximum (ms) field, type the number that your network service provider recommends.

    Valid entries are 20 to 1000, in increments of 10. The number that you type in this field must be greater than the number that you type in the Received Digital Metering Pulse Minimum (ms) field.

    The system displays this field only when the Signaling Mode field is set to cas, the Interconnect field is set to co or pbx, and the Country Protocol field is set to a protocol that uses PPM as defined in Country protocol codes for incoming digital PPM signaling.

  3. In the Received Digital Metering Pulse Minimum (ms) field, type the number the number that your network service provider recommends.

    Valid entries are 20 to 1000, in increments of 10. The number that you type in this field must be less than the number that you type in the Received Digital Metering Pulse Maximum (ms) field.

    The system displays this field only when the Signaling Mode field is set to cas, the Interconnect field is set to co or pbx, and the Country Protocol field is set to a protocol that uses PPM as defined in Country protocol codes for incoming digital PPM signaling.

  4. In the Received Digital Metering Pulse Value field, type the number that your network service provider recommends.

    Valid entries are 1 and 2.

    The system displays this field when the Signaling Mode field is set to cas, the Country Protocol field is set to 21, and the Interconnect field is set to co or pbx.

  5. Press Enter to save your changes.