Enter change tenant n, where n is the tenant that you want to change.
The Tenant field is a display-only field. This field contains the tenant number that you typed on the command line.
In the Tenant Description field, type a description of the tenant.
You can type 40 characters. You can leave the field blank, but a description helps you identify the tenant when you change other information about the tenant.
In the Attendant Group field, type the number of the attendant group for the tenant partition.
The system assigns the number 1 as the default for the Attendant Group field.
The default for the system is that all attendant groups exist. However, the attendant group is empty if you do not assign consoles to the attendant group.
In the Ext Alert Port (TAAS) field, perform one of the following actions:
If trunk answer from any station (TASS) alert port information does not exist, type an x.
If TASS alert port information exists, enter the 7-character port number.
The media module must be installed and defined to the system before you can refer to the media module in the Ext Alert Port (TAAS) field. The port type and the object type must be consistent. You can assign the port to only one tenant.
Table 1: Port information for the Ext Alert Port (TAAS) field
Characters
Description
Value
1-3
Gateway number
G4xx Media Gateway Number
4
Gateway
V
5
Slot number
1 through 8
6-7
Circuit number
Port number on media module
In the Night Destination field, type the night service station extension, if you want night service for the tenant.
Type an extension that already exists in the system.
In the Ext Alert (TAAS) Extension field, type an extension that already exists in the system.
Note that, the system displays the Ext Alert (TAAS) Extension field if you type an x in the Ext Alert Port (TAAS) field.
In the Music field, type the source of the music or the tone for the tenant partition.
Select Enter to save your changes.
Click Next until you see the Calling Permission area.
Note:
The Tenant field is a display only field. This field contains the tenant number that you entered on the command line.
In the numbered fields, perform one of the following actions:
To enable calling permission between the tenant that you entered in the command line and any other tenant in the system, type y.
To disable calling permission between the tenant that you entered in the command line and any other tenant in the system, type n.
The system default for the calling permissions are to:
Allow the tenant to call itself
Allow the tenant to call tenant 1
Turn off all other calling permissions between tenants
